1. Open the laparoscopic training box, insert the support plates on both sides into the corresponding sockets, and insert the pins into the corresponding circular pin holes;
2. Insert the USB cable plug into the computer USB socket, adjust the power switch on the cable, and adjust the brightness of the appropriate light source;
3. Take out the video camera device, fix the suction cup on the base of the camera device, and then fix it next to the oval camera port, loosen the fixing screws of the camera device, insert the half camera into the oval camera port, and insert the USB video cable into the computer USB port , open the video software;



4. Put the training module into the laparoscopic training box;
5. Adjust the video camera device to a suitable angle and height, and fix it with fixing screws;
6. Insert surgical instruments and perform training.




Post time: Dec-28-2022