Laparoscopic simulator installation instructions
1. Open the smailmedical laparoscopic simulator, insert the two support plates into the designated positions, and insert the fixing pins into the fixing holes;
2. Take out the power cord of the LED light source, insert the USB interface into the computer, turn on the switch to test, and adjustthe brightness of the light source at the same time;
3. Take out the smailmedical simulation laparoscopic efficacy camera, fix the four suction cups on the camera base, then fix the camera on the smailmedical laparoscopic simulator, adjust the appropriate angle, and connect the USB cable of the camera to the computer ( monitor), turn on the computer monitoring system;
4. Put the training module into the smailmedical laparoscopic simulator and adjust the position and angle of the camera;
5. Insert the operating instrument into the operating hole of the smailmedical laparoscopic simulator, and make the final adjustment to the angle of the camera. After the installation is completed, it can be used normally.
6. If you don't have a computer monitor, you can also directly use a plywood computer or a mobile phone as a monitor.
Post time: Apr-18-2022
